I have an issue with the sealed chamber cover on my Glowworm 24ci. I recently had the boiler serviced and it was working fine for a couple of weeks and then it started reading fault 'F2' which according to the user manual means there is "Air fault, pressure switch, no power to fan."
I took off the outer panel off and the sealed chamber cover off and checked inside and could not see any issues. I switched the boiler on while the covers were off and it ignited fine and was working perfectly. I then put the sealed chamber cover back on and it stopped working and flashed 'F2' again. I removed the sealed chamber cover and it reignited. I checked to see if there were any wires touching the cover and could not see any.
I currently have the put the outer panel back on but left the sealed chamber cover off so that the boiler works. Can anyone help with this issue? Is this a common problem with this boiler?
I took off the outer panel off and the sealed chamber cover off and checked inside and could not see any issues. I switched the boiler on while the covers were off and it ignited fine and was working perfectly. I then put the sealed chamber cover back on and it stopped working and flashed 'F2' again. I removed the sealed chamber cover and it reignited. I checked to see if there were any wires touching the cover and could not see any.
I currently have the put the outer panel back on but left the sealed chamber cover off so that the boiler works. Can anyone help with this issue? Is this a common problem with this boiler?