Hi
I have an intermittent f1 fault on my glowworm 18hxi
I've checked the firing sequence, and can see that the spark is healthy, the boiler ignites, burns for approx 5 secs, then stops, repeats this sequence two more times, then stops and shows F1.
When it lights, it doesn't start to modulate at all. If I reset it a few times it will start,once its started it's then fine. It will then kick in every time on demand until it's been sitting overnight.
Any ideas ?
I guessing that the flame detection may be kicking it out ?
Thx
I have an intermittent f1 fault on my glowworm 18hxi
I've checked the firing sequence, and can see that the spark is healthy, the boiler ignites, burns for approx 5 secs, then stops, repeats this sequence two more times, then stops and shows F1.
When it lights, it doesn't start to modulate at all. If I reset it a few times it will start,once its started it's then fine. It will then kick in every time on demand until it's been sitting overnight.
Any ideas ?
I guessing that the flame detection may be kicking it out ?
Thx