I've just had a Heatmiser PRT-W wireless kit installed with my Worcester Bosch 30CDi boiler. I'm having problems pairing the wireless stat with the receiver.
I've followed the following steps, as per the documentation:
- Pressed and held the pairing button on the receiver for a few seconds until the red comms light lit up
- With the transmitter turned off, held the "A" button until it turned on - the RF signal icon started flashing
- Waited and waited....
The red comms light on the receiver remained solid, and eventually went out after a minute or two, without flashing (or pairing).
Does anyone know any tricks for getting these units to pair?
I've followed the following steps, as per the documentation:
- Pressed and held the pairing button on the receiver for a few seconds until the red comms light lit up
- With the transmitter turned off, held the "A" button until it turned on - the RF signal icon started flashing
- Waited and waited....
The red comms light on the receiver remained solid, and eventually went out after a minute or two, without flashing (or pairing).
Does anyone know any tricks for getting these units to pair?
