The new sink that my wife has chosen is about 1/2" longer and wider than the old sink. To get the drainage lined up & to fit within the units I need to take off about 1/4" all the way round. FYI It's a 38mm laminate top.
I've never done anything like this before so I'm guessing I make a template from plywood/MDF to cover the hole and to give support to a router.
If so, which blade is recommended?
If that's not the right way, then any advice on how I should do this would be welcome.
I've never done anything like this before so I'm guessing I make a template from plywood/MDF to cover the hole and to give support to a router.
If so, which blade is recommended?
If that's not the right way, then any advice on how I should do this would be welcome.