Ideal boil L-F error

[Leasharpe]

Having a slight problem with my boiler. I keep getting the L-F code. Not all the time, if I reset it it is fine, I can get both hot water and heating, however now and again it's reverting back to the L-F code. Gas into the house in fine and as it's a bit of an intermittent fault I'm not too sure. Any ideas?

 

[Agile]

Its a combustion/ignition fault. But we don't give DIY repair advice for those faults here.

Has it been properly serviced lately?

The only advice is to get a good gas reg engineer.

Tony

 

[Gasman28]

Does your condense pipe run inside or out? If inside, it might go to a sink waste for example - this might be blocked. If outside, check to see if it's blocked by leaves etc in the gulley.