2
2scoops0406
Wondering if any of you could give me the benefit of your wisdom before I plough on. One of the doors on our kitchen units has been a bit loose for a while, well today, it finally half fell off. Inspection reveals that the holes that secure the plate onto which the door hinge attaches have become enlarged to the point where to screws do not tighten, but simply spin round.
Apart from replacing the carcass (best solution I know, but of course sods law says it's the under sink unit that's gone) does anyone have any good ideas as to the beat way to enable the hinge attachments to be secured properly again?
Simply fill it drill it?
Forstner bit, plug, and drill into this?
I don't want to glue the fixings, 'cos then I can't adjust them, and I can't use larger screws.
Thanks in advance.
Apart from replacing the carcass (best solution I know, but of course sods law says it's the under sink unit that's gone) does anyone have any good ideas as to the beat way to enable the hinge attachments to be secured properly again?
Simply fill it drill it?
Forstner bit, plug, and drill into this?
I don't want to glue the fixings, 'cos then I can't adjust them, and I can't use larger screws.
Thanks in advance.