Hi All,
Every time I repair holes in plasterboard, fill the hole/sand it down etc etc, even if I use the same tub of paint, the repaired patch is loads darker than the rest of the wall.
Is there a way to get it of equal darkness? Ive tried watering down the paint prior to application but the same thing happens.
Also when you have something to hang with 2 screws on opposite sides, what is the easiest way to measure where to drill correctly? I end up measuring the distance between the screws, then distance from each screw to the ceiling etc and it makes it difficult
Every time I repair holes in plasterboard, fill the hole/sand it down etc etc, even if I use the same tub of paint, the repaired patch is loads darker than the rest of the wall.
Is there a way to get it of equal darkness? Ive tried watering down the paint prior to application but the same thing happens.
Also when you have something to hang with 2 screws on opposite sides, what is the easiest way to measure where to drill correctly? I end up measuring the distance between the screws, then distance from each screw to the ceiling etc and it makes it difficult