Hi al
I have had to replace a wired Drayton Thermostat with a wireless RF3 as I believed it would be easier than running new cable under the floor etc.
Anyway they both use the same backplate (see pix) and are wired the same way (ie: N- blue, L- Red, Call-Yellow) So when I power off the boiler controls and power on with the new SCR in place, the boiler does not click on when I push the override. When the old dial thermo is put back it clicks on straight away. According to the instructions I cannot continue to pair up the SCR with the WiFi thermo until the overide is working.
Anybody seen this before
thanks in advance
I have had to replace a wired Drayton Thermostat with a wireless RF3 as I believed it would be easier than running new cable under the floor etc.
Anyway they both use the same backplate (see pix) and are wired the same way (ie: N- blue, L- Red, Call-Yellow) So when I power off the boiler controls and power on with the new SCR in place, the boiler does not click on when I push the override. When the old dial thermo is put back it clicks on straight away. According to the instructions I cannot continue to pair up the SCR with the WiFi thermo until the overide is working.
Anybody seen this before
thanks in advance