Hi All,
I was hoping to replace my old 600x600 single convector with a chrome towel rad...
My existing pipe are approx 686mm centre to centre and 40mm from the wall to centre...
The existing pipes are pulled bends under the stud partition so to get back to a straight for any new fittings will mean lifting boards both sides of the partition (a nightmare as they've been botched and overboarded by the previous owners).
I've been looking online at various towel rads but don't want to get lumbered if I order the wrong size.
Has anyone found or can suggest a way of fitting one in with the existing pipe centres without it looking botched?
I thought maybe order a 700+mm wide and using angle valves and elbows but not too hot ( ) on rad fitting dimensions.
Any advice appreciated, failing this I'll just have to go for another 600x600 type 11 compact...
I was hoping to replace my old 600x600 single convector with a chrome towel rad...
My existing pipe are approx 686mm centre to centre and 40mm from the wall to centre...
The existing pipes are pulled bends under the stud partition so to get back to a straight for any new fittings will mean lifting boards both sides of the partition (a nightmare as they've been botched and overboarded by the previous owners).
I've been looking online at various towel rads but don't want to get lumbered if I order the wrong size.
Has anyone found or can suggest a way of fitting one in with the existing pipe centres without it looking botched?
I thought maybe order a 700+mm wide and using angle valves and elbows but not too hot ( ) on rad fitting dimensions.
Any advice appreciated, failing this I'll just have to go for another 600x600 type 11 compact...