Basically we have just removed a bath + tiles from the bathroom and we would like to install a bath shower riser, but the area where the taps originally were, are not suitable to install a shower because it is basically facing a window with a ledge.
The only way i think this is possible is to turn the bath around 180 degrees and to extend the plumbing to the other side of the bath. I think the waste will be a very simple job as it is just extending the original (brown) pipe which is already there but in regards to the hot/cold pipes will it be best to use a pipe cutter to cut the pipes down and then use a long (50cm) flexible tap connector?
Any advice appreciated. Thanks
The only way i think this is possible is to turn the bath around 180 degrees and to extend the plumbing to the other side of the bath. I think the waste will be a very simple job as it is just extending the original (brown) pipe which is already there but in regards to the hot/cold pipes will it be best to use a pipe cutter to cut the pipes down and then use a long (50cm) flexible tap connector?
Any advice appreciated. Thanks