Hi,
I want to make an outdoor table tennis table. I have a 7ft by 5ft trampoline that I was going to use as a base and just put the tt table on top.
I was thinking of using two pieces of painted 18mm WBP plywood joined in the middle with 3 loose pin hinges. I like the idea of being able to hinge one end up for solo play and being able to separate the it into two halves. Probably run 3 pieces of 50x50mm underneath for support.
Anyway, has the forum any experience of doing this or suggestions? In particular the use of plywood. Would any other sheet material be better?
Thanks Steve
I want to make an outdoor table tennis table. I have a 7ft by 5ft trampoline that I was going to use as a base and just put the tt table on top.
I was thinking of using two pieces of painted 18mm WBP plywood joined in the middle with 3 loose pin hinges. I like the idea of being able to hinge one end up for solo play and being able to separate the it into two halves. Probably run 3 pieces of 50x50mm underneath for support.
Anyway, has the forum any experience of doing this or suggestions? In particular the use of plywood. Would any other sheet material be better?
Thanks Steve