Hi,
In the middle of hooking up a new cold water cistern. The kit came with a tank connector with a rubber washer for the inside and plastic washer for the outside.
The instructions say just assemble it and screw it up. It looks a bit dodgy though - is it best practise to dose a load of silicone sealant on the washer and tank connector before hooking it up in a similar fashion to a bath waste?
Of course, that means not filling the tank for 24 hours while it sets..
Thanks in advance.
In the middle of hooking up a new cold water cistern. The kit came with a tank connector with a rubber washer for the inside and plastic washer for the outside.
The instructions say just assemble it and screw it up. It looks a bit dodgy though - is it best practise to dose a load of silicone sealant on the washer and tank connector before hooking it up in a similar fashion to a bath waste?
Of course, that means not filling the tank for 24 hours while it sets..
Thanks in advance.