I can understand it sticking closed, so the rad would stay cold, but sticking open makes no sense to me. If I push the pin down, it moves easily, so why is the plunger not working.
I expect it is the thermostatic mechanism in the head that has failed. It is quite easy to swap the heads without having the take the valve off. What brand are they?
If you have a combi or a system boiler you should be able to change the TRV without draining down - provided the filling valves any any air valves are closed. If you have a vented boiler, get a Drayton Draineasy kit from the local DIY shed or plumbers merchant. It's a couple of rubber bungs which go in the feed and vet pipes in the F&E tank.
In both cases you get a vacuum in the system, so water cannot escape when you disconnect the valve. I fitted 13 TRVs at my last house by using bungs without any spillage. (Though it can be a bit scary seeing water lapping at the top of an open pipe sticking out of the floor!)
Giving things a thump with a hammer is not the answer. Has anyone thoughtthat the rubber washer has perished andisnot sealingtheinside of the valve. If i had seen that problem for 12.50 for a complete new and 30 mins work I would of just got on and changed the valve. Job done
Giving things a thump with a hammer is not the answer. Has anyone thoughtthat the rubber washer has perished andisnot sealingtheinside of the valve. If i had seen that problem for 12.50 for a complete new and 30 mins work I would of just got on and changed the valve. Job done
sorry that did come accross abruptly as i wasnt following the thread. If the radiator wont come on with the trv in the fully open position the rubber has stuck and a gentle tap with a wooden batton will clear this, taking care not to wak the copper tube. If the radiators not turning off rubber has perished, probably due to chemicals used on flushing the system. My advice allways change slightly faulty parts as this will save calling out a plumber twice for the same job.
I thought I'd have to change it, but draining the system is a pain and adding the anti corrosion chemicals adds £10 to the job every time I do it.
I'll change the two brand new ones the installer put on at the same time as they have the narrow bore inside and I'm sure that's why the CH now makes a high pitched hissing noise from the rads.
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local