Hi all,
Hoping for a bit of input on a kitchen island im just about to install.
We are having an island 4x2 base units, so 2400 x 1200. Laminate worktop (one piece).
The wife wants a breakfast bar in oak overlapping the laminate at one end, but without an upstand!!
The oak would be 2000 x 600. So i was thinking having a 300 overhang on the width, and a 600 overhang on the length.. (see pic)..
Now im sure that the 300 overhang will be fine, it's just the 600 overhang that im worried about! I was planning to screw from underneath through the laminate into the oak, maybe even adding a few plates/large washers for extra support etc.
Whats your thoughts? i don't want that 600 snapping if someone leans on it.. I've seen it done, so jusy after some advice..
Hoping for a bit of input on a kitchen island im just about to install.
We are having an island 4x2 base units, so 2400 x 1200. Laminate worktop (one piece).
The wife wants a breakfast bar in oak overlapping the laminate at one end, but without an upstand!!
The oak would be 2000 x 600. So i was thinking having a 300 overhang on the width, and a 600 overhang on the length.. (see pic)..
Now im sure that the 300 overhang will be fine, it's just the 600 overhang that im worried about! I was planning to screw from underneath through the laminate into the oak, maybe even adding a few plates/large washers for extra support etc.
Whats your thoughts? i don't want that 600 snapping if someone leans on it.. I've seen it done, so jusy after some advice..