i have flashing right hand light on the facia. I have changed the flame sensor electrode, and overheat thermostat. pcb was replaced some months ago believed ok. boiler works for 20 mins then locks out. i have discovered everything works fine - hot water and radiators - when the inner cover is removed from the boiler!!
worcester 24cbi lockout problems - help??
- Thread starter nicholasb
- Start date
Sponsored Links
- Joined
- 22 Jul 2005
- Messages
- 1,101
- Reaction score
- 821
- Country
SOunds like it could be a flue problem. Check it's not blocked!
B
B.O.B DOLE
nicholasb said:
have u checked the pump no air lock
- Joined
- 4 Oct 2005
- Messages
- 555
- Reaction score
- 0
- Country
See the thread on Halstead Finest Gold locking out.
I'm not sure if they use the same fan, if they do check the venturi is clear.
I'm not sure if they use the same fan, if they do check the venturi is clear.
Sponsored Links
jiminblack said:
Done that - and touch wood it is working fine - thank you SO much
cleaned out the flue and venturi - it is now working THANK YOU THANK YOU THANK YOU
Hi - I think I've had the same problem with my 1999 Worcester for the past 2 years now on and off. The guy (who claims to be a heating engineer specialist, not a "plumber") who does the landlords safety check hasn't in this time actually been able to resolve it though - despite replacing sensors etc. He has never mentioned the potential flue/venturi thing which sounds like exactly what I may have got an issue with.
In a nutshell, what I am after is somebody decent in the central York area? Any ideas. I thought the guy I was using was good but he's evidently just passing time and not really interested.
Any help would be appreciated.
CDG
In a nutshell, what I am after is somebody decent in the central York area? Any ideas. I thought the guy I was using was good but he's evidently just passing time and not really interested.
Any help would be appreciated.
CDG
cdg said:
It`d be a wonderfull world if we all new everything we were supposed to.
pierrot said:
Yes. Yes, it would. As I say, he specializes in boilers but has not once suggested a flue issue or venturi (despite having three cracks at the whip), both of these seem to crop up on this site quite a few times.
I could have just asked for a recommendation for York I suppose but I figured some back ground would be useful.
CDG
Hello all I am experiencing problem with Worcester 19/24 CBi woke me this morning by trying to start up continuously, goes through spark then momontarily fires then shuts down and starts sequence again, looking at manual fault not really covered by light sequences. My initial thought is flame sensor can this be cleaned? spade connector on lead looks a bit naff will replacing cure problem? Any test for sensor?
Please advise
GaryH
Please advise
GaryH
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
