Recent content by 11Mike

I’ll have a look but pretty sure we checked it when we fitted it. If it doesn’t i’ll just swap the current one out for the magnetic one.

That was why we fitted it at the bottom but as I said, when it is open it end up being a stepping stone, ha. Do you think it is worth fitting where I was planning or just stick with a magnetic?

Thanks for the reply, I thought it was going to be ok but realised afterwards it is a poor place, ha. Here is a picture of the door. It is pretty tight to try anywhere else to be fair. I might have to stick to the magnetic on then.

My intention is to fit a magnetic in the gap at the side of the door (red arrow) and move the impact sensor to the other side of the sliding part (blue arrow), underneath like it is now. The reason is that if the door is open the dog keep catching it as she runs through. Also we want a...

Ah right, so I’d need to disconnect it in the control panel first then? I wasn’t sure if it could be done via the local panel using the engineer code. I’ll post a picture showing what I want to do.

Hi, first post here. I am after disabling one of my Texecom Premier Impaq sensors so I can remove it. I know my engineer code. I have looked through the manual but can’t see anything other than omit zones. My first question is do I just set that to omit to be able to remove it, does this...