Recent content by 1iydwilly

He definately wont have any water in his manometer with a working pressure of 21bar. Back to top that wasnt standing pressure that was working pressure beleive it or not!! all i can do is tell you what is happening......thanks to those with sensible replies tho....will check the filter...

im sure.

hi im working on a worcester 24sii ll non condensing combi boiler...the water is coming out luke warm and the more i open the tap the colder it gets..i suspect that the gas pressure is low i checked the working pressure at the meter and thats ok 21 bar....but when i check the inlet pressure at...

i have a heating system on a conventional boiler and most of the rads are working fine....but 2 are not....ive descovered there is a blockage maybe sludge or something in the affected area....but my problem is how do i clear it? the pipes are under a concrete floor so was looking at flushing...

i have a mira sport 9kw shower....i turned it on one day on the high setting and it kept tripping the switch...so have only been using it on medium where its fine....today i cleaned the inlet filter and put it back together ...but the problem is the pressure is crap...it heats the water but the...

i have also come across one of these boiler systems...looks the same as above but on the hot water side...the cylinder had to be changed so the plumber changed the cylinder and when it was refilled the hot water from the boiler is not circulating around the cylinder!!! being gravity fed this can...

rom scratch...its a ground source heating system

it says i have to work out the system volume then add 90 litres & the expansion size is 4% of the total volume....just how do i work out the volume?

im installing an unvented heating system but am unsure of the size of the expansion chamber on the heating side i should use...is there a simple system of working this out? i know i have got to work out the total pipe length & size & the size of the radiators etc...but if someone could tell me...

the push button prob unscrews...grab the pushbutton device and screw anti clockwise this should get it off so you can access the cistern

I'm assuming that the HW really does work as expected with CH turned off and CH works when HW not drawn. When HW is drawn with CH on, you say the water is cold but does hot water continue to flow around the central heating circuit? **yes the hot water continues to flow around the heating...

im giving all the info i can....my first post is the situation....thats the symptoms im getting.....the boiler was put in 2 yrs ago and has been working fine until this week....

ok so it is possible it is the diverter valve then...will give this a go...thanks...

the boiler is only 2yrs old...if this helps...

its an isar 24 ....the diverter valve is red when the heating is on & turn the tap for hot water the display does read d...but water comes through hot for a couple of seconds...then goes cold