Recent content by 1plus2

Hi if any plumbers out there or members that have had similar work done could help me. Wondering about a ball park figure for a plumber to fit 2 service valves under the sink to cut water off instead of using main valve which is awkward to get to thx in advance Area is Livingston in Scotland.

Thx for the replies guys much appreciated i think what is getting to her is the fact that the temperature on the LCD display is sitting at roughly 20.5 so it needs to be set at higher than that for the heating to kick in. Even tho it's an RF model the guy fixed it to the place where the old...

It's a TP5000 SI-RF. Regarding the settings the 13 C ones were basically set at that so it goes off as it does not have an off/on button like her old one did which she was used to. As you probably guess i have limited knowledge of how these things work myself so sorry if i am being a bit...

lol i like the cut of your jib but without changing what is there have you any other pearls of wisdom for the issue thx

My Mum has got this Danfoss thermostat and she is finding it hard to get used to (she is 84) what i am wondering is there anyway this can be used where she can turn the heating on and off manually without any pre-settings ? I notice there is no off or on buttons or automatic turn on buttons...

Thx for the replys guys and yes it does work on a higher setting its a small rad in the bathroom. The reason i set the stat at 28 was to see if this would make the rad kick in @ setting 2.

Hi wonder if anyone out there can help me. If a TRV is set at setting 2 and i turn my heating on should that rad that has the TRV @ 2 heat up. The thermostat is set at 28 degrees and the rad still doesnt seem to heat up @ the 2 setting.

I now think it is 1 of the boards as i tried a diff cable and the same scenario flickering but it does not flicker all the time sometimes it comes on without the flickering. Would it likely be the power board or the main board ? thx

Power cable

I have an Acoustic solutions lcd tv when switched on sometime the pictures start flickering up and down but when you move the cable this sometimes stops the flickering. Is this likely to be a power cable issue or is it down to the power board being faulty possibly ?