Recent content by 2020c

Where you looking all thst beautiful brick and blockwork removed above the rsj, remove the rsj, install new and build all back up with blockwork. Any roof work included in it? Im.still confused as to what you wanted done.

Ive read your post a few times and confused. Your saying "I" have had the chimney stack removed and i need to remove the bricks left from the chimney stack then its someone trying to rip of your sister? Also, where are you getting she would have lost 4k? Do you think all this work should be 1k?

Whst exactly was quoted for? You say removing a few bricks? Please add everything that was quoted.. Is there scaffolding needed? Is there skips included? Is all materials included and whst about vat. Is he vat regiestered or just a sole trader working under the vat threshold. Is he...

Its now cut and up. 1/3rd of the plumb cut :cool:

I know, wheres more than 1/3rd talen puton the pics above. Its exactly on the limit thst what can be cut.

Am i correct in thinking that its a 1/3 of the timber now it takes on a new angle rather than just a 1/3 of the width of the timber at 145mm The height above plate is 126 + 63 mm = 189mm. 1/3 of that is 63mm. Can i cut these measurements rather than what i have in my drawing above which is...

Thoughts on these measurements for the seat and plumb cut

.

Gable roof. They are to join double rafters and joists at 400mm center holes. And to secure wallplate to a steel beam..

Maybe im ovee thinking it but if the joists are 44mm and the rafters are 40mm then somewhere itll end up out when its time to put the plasterboards on. Aloughth these joists are 40-44 mm and 218-225mm. When setting the floor level or of the wall plate its throwing my overall floor levels out...

If one has 9x2s for the joists and it is 44mm wide and 6x2s for rafters and its 40mm wide. Which one do you center of for the 600mm spacing.

O i know, best to follow the regs and stick to them. What im now curious about and cant swem to find any pics or videos online with it is tge actuual doubling up of them. If the two joists are side by side, do tge rafters be on the outer sides of these joists. Ive installed lots of trusses...

Builders yard exchanged the discoloured and damaged c16 6m lengtha for 6.6m c24 with slight discolour at the sides at no extra cost.. happy with this now.

Ill have to slightly adjust the spacing now for where i have triple rafters and joists as ill only be needing two together now instead. Do i need to double up for the ope for staircase or will i be ok with just a trimmer on the joist with joist hangers each side?

Add two plus the one was there or doubles i need instead of 3. I do have a few roofing books from years ago ill have to dig out. I seen this online and it caught my attention. Doubles with pieces in the center for even larger opes.