Recent content by 88stevo

I am just wondering if I can somehow pull this van door dent back into place. Doesnt need to be perfect just looks like I could get under neath with a crow bar or perhaps bang from inside? Like I said not bothered about perfect just want to improve

I'm just looking for someone to instruct me where to put each wire and position the bridge please

Replacement for ceiling rose

My friend has tried installing a new light and has removed the ceiling rose without taking picture of the wires. I am going to have a look for him tomorrow but hes sent me a picture of his worrying attempt which as you can tell with arrangement has tripped his circuit. I have attached picture if...

heres the pictures...its driver side door vauxhall vivaro 2005 1.9 diesel

As in title i have replaced van door (vauxhall vivaro) not sure how to connect central locking port. I have bolted the new door on but the wires came out of the port which connects back into the van to connect the central locking & speaker, not quite sure what wire to put there at theres about...

And how would I use such a device like how would I know what goes where from using such meter

all switches are one way and only controlled from this point. i have set it up as following - permanent single live going into COM and bridges going into a further 4 COM slots. 1 twin/earth going into L1/L2 opposing original perm live COM. Single core red next L1/L2 Single core...

yes of course? why would they not be... every wire in the wall has grey sheathing

everything is rcd protected and all the cables are sheathed, i have converted the back of the garage into a room so wanted the cables hidden. unfortunatley i do not have a multimeter

Hi, I took a picture of how a light switch was wired before i removed from conduit and chased wires into wall. Now I have lost my phone with the pictures! it is a 6 way light switch which i belive only controls 3/4 lights. I have the following wires - Single red core x 2, single...

its a 3/4...8.5ft x 4.5ft

ok, heres what iv done and it seems to have worked, every switch is changing what its supposed to etc but il just check it over with you guys. fig 10 is now fig 6 wires up into a junction box that will lie above the ceiling and i have added 2 separate 1.5 twin/earth that will power 2 light...

hi everything you said is correct apart from the fact that all the lights were controlled by different switches which is what is confusing me