Recent content by 98webp

Thanks, I'm sure ill figure it out if its that simple. All the best.

The plumber is fitting the 2 x port valves so it will be changed to an S Plan. Thanks for everyone's input. If anyone has a diagram for the wiring that would be appreciated. Alternatively I've found a few online which should aid me. Thanks again

Should be an easy straight forward swap and will be better to have a proper set up.

Thanks Ian. I'll speak with the plumber about adding the 2 x 2 port valves instead of the 3 port and then once sorted will post again for some advice regards the wiring as I already have everything else. Only started using this site and appreciate the quick replies and useful information...

Ianmcd, Many thanks for the information. I had a look online regarding the 3 port valve and unfortunately it appears you are correct. Shame my gas engineer/Plumber wasn't better informed. If anyone knows the wire connection for my current set up that would be appreciated. (i'm aware that when...

The current active valve has a Hive receiver for the hot water tank and the radiators. I need the new hive receiver to open/close the new single valve? The 22mm pipe work connected to the single vale has been added and only goes to the garage. So I was hoping to install a new hive receiver to...

Could someone please take a look at my Boiler/Hive set up and let me know what I need to do to install: 1 x HIVE single channel Receiver I have; 1 x heating valve installed and ready to go (black wire in red box), which will feed my garage conversion consisting of 3 radiators (heating only...