Recent content by Aaron Kent

It’s the Q20 PIR

Just an update on this after the recommendation I was still having issues. I have now deleted the device and readded and so far all seems to be working as it should. Thank you to everyone that spent time and contributed.

Thank you for the above this is very helpful. I always put the PIR to always on as I found sometimes they do not always wake up and can be walking around when set for a bit before detected. I will raise with Texecom to see what they say but I think they will tell me virtually what you said as I...

Will try the force omit. I had the DT's on last system with no issues. To set the alarm i use keypad 1 this is next to the front door, I open the front door so the front door contact will be open and then set the alarm. Close the door but then you can hear the alarm does not set. PIR 11 which...

sorrys its the Q20-W for the front door

Thank you for everyones advise. The PIR is a Wireless P20W I think.

Its definately related to the PIR on the exit door. I can set the system easily using the app so seems like the PIR is staying connected when arming.

The system is set as entry exit so the door contact should then set the system. I had exactly the same programming and design in last house and didnt have same issue.

I have self installed the Texecom alarm system and have installed a few but struggling with arming error. 75% of the time it fails to arm and looks like the PIR on exit is causing the issue, I can arm remotely and have no issues. Checking the programming and cross referencing with previous...

Just two questions...after a bit of advise I have installed a wireless sounder and its detected on the zone but the Zone type has been listed as Custom and no other options ticked is this correct ? Do I need to tick the bell/strobe in the Custom Zone ? Next question is Part arming at...

thanks all for your help

ok strange thing, now working and all i done was enter the details back in..

The Smartcom is connected via ethernet straight into my network switch and getting DHCP IP address, I can ping the device. Im actually going backwards now as cannot connect to the panel using Wintex wireless like earlier, I played with the port details on Com 2 and now cannot access but...

actually does not matter what firmware the Smartcom is.

Think you may have answered my question, not sure if V1.01 works with V4 Panel is V4 Smartcom 1.01 All lights are on the Smartcom just Wireless light flashing.