so the switch was labelled water heater I assume its a 20A switch. The supply cables to the switch are 2.5mm I think, the neutral cable was burnt out. I have never seen 2 immersions connected to the same switch or same MCB its not normal practice is it? the customer wants to know if this could...
Hi, I was called to a job today where the property had no hot water, the double pole switch would not switch, I removed the face plate and could see the neutral wire burnt out. I have replaced the switch with a new one.
The double pole switch feeds a Quartz E7 timer which switched between peak...
Hi i have a potterton performa 28 and when the hot water is turned on the boiler fires up and shuts down after about a minute untill the temperature goes below 80*c then fires up again but at no point does the water get hot.
Could this be the dhw heat exchanger or dhw thermisitor or anything...