Recent content by Adrian E

  1. A

    Going smart control on existing Glowworm / ESi setup

    Just to close off this thread, I did complete the installation in November 2021 and now have Wiser installed using their Kit 3, with 12 iTRVs and having left 4 original TRVs in place in the bathrooms and a walk in wardrobe. The plumbing install was straightforward enough - a couple of new TRV...
  2. A

    Going smart control on existing Glowworm / ESi setup

    OK, been doing some more research of my existing setup and figuring out what needs to change if I go for the Wiser setup, just to make sure there's no trip ups at the point I'm committed to disconnecting things! So the layout of the system is standard S config 3 valves: (Please excuse the...
  3. A

    Going smart control on existing Glowworm / ESi setup

    Thanks - that's the basic system I was assuming I'd need :) Interestingly the datasheet at your link is the first place I've seen any mention at all of hot water control, and that states that it will use the existing cylinder thermostat to control hot water temperature. If that's the case, it at...
  4. A

    Going smart control on existing Glowworm / ESi setup

    Hi all Been reading (a lot!) about different options for smart control of central heating systems, and trying to narrow down what my choices are, and any specific points with the existing configuration that impacts on choice. Based on reading to date, I think either the Honeywell Evohome or...
Back
Top