Recent content by Ahab36

stephenleespooner?? sorry to here that your faith in glowworm is as bad as you say. all thou you never did answer my question on servicing? and i would look at the person who installed it for you. regarding inhibitors and inline system protectors??? I fitted twenty five CXi's last year and no...

Don't give up on your Glowworm they are a very good boiler when installed correctly and serviced regularly?? You will probably find that your pressure sensor has gone up the suwanee. You will need to replace the pressure relief valve aswell to stop the leaking?? I would suggest you do these two...

Hi, regarding your question about the 22mm pipe the answer is yes? all hot water supplies should be in 15mm unless stated by the boiler manufactures as some combi/store units can supply hot water using 22mm pipe. you could increase the cold incoming main to 22mm around the house as this well...

don't know if this is going to be of help to you? as you will obviously get some advise from your plumber tomorrow. but, you have already answered most of you problem in your question. water mains?? if you plan on changing your main does that mean you have a lead main at the moment and if so why...

thats wot i thort was being fitted???? If its just a normal wood burner then i would suggest using low and high pipe stats to energise the pumps. but make sure your Electrician or heating engineer understands how it works. I myself use this method many times and find it works well. please...

if i was you i would try and control the two systems seperately. rads and the ufh. that way you can always turn one off without it effcting the other. please do fit a bye-pass on the rad circit and i would strongly recommend you buy a ufh kit with pump,pipe,valves and a built in bye-pass. there...

Hi i'm here again after some help with this bentone B9C burner. Thanks to those who sent a message back to me but alot of wot you have suggested i have already tried or know?? However, any further help would be appreciated. Been to the boiler this morning for four hours. Two of which I...

Thanks John. Oil pressure set correctly, Photocell ok. It worked all ok over the weekend then come Monday Morning it stopped. Think it is some ignition problem, but not sure what else to try - everything is set up by the book, but just stops when I leave!! Ahab

Hi Tony, Thanks for your reply. Yes the electrodes are spaced correctly and there is a voltage charge that runs through it. Is the flame detector the photo cell???? When it is ignited it does sound as though it is coughing and spluttering. I don't suppose you have a contact number...

Help! I'm having problems with a Bentone Burner B9C...can't find any web sites or contact numbers for a tech line to help me out. does one exist???? or can anyone help me with this dilemma? basically burner fires nearly everytime i'm there... i leave and it stops working. the oil pump...