Recent content by AJS

Ken, I would think that you would be hard pressed to do ths job without instructions. You might find some resource here on the web - I know that Trend <www.trendmachinery.co.uk> do a jig and they have regular newsletters, so perhaps take a look there. I agree with the above though that you...

Thanks for the response(s), looks like a new unit then! It's a shame that they incorporate a non serviceable thermal cutout as opposed to something that you can simply reset or replace with ease. I guess they don't want things fixed anymore!

Help!, my Tefal "smartclean" deep fat fryer has broken. I've looked inside and it looks pretty simple. I have checked most of the bits (switches, element, etc) for continuity and all are OK apart from one thing that looks like an overheat cutout. It appears to be a small plunger on a spring...

Well I'm not a plumber, but I do have a similar boiler, and a similar problem. I found that one of the plugs on the electrical board was hitting the earthing tag on the case and had damaged the connection. I resoldered and it worked OK for a while, but now works very erratically. I posted a...

If it helps, I did it and I am an average DIY'er. The biggest problem was not having a bath or toilet whilst the work was going on, cos I am really slow. I also had some leaks on the cistern inlet that took a couple of attempts. So long as you have the usual set of tools, screwdrivers, etc, you...

Have a glowworm Micron 50FF. Ocassionally the thing shuts down - no heating or hot water. A reset usually cures. When operating OK it often starts the ignition sequence, then within seconds stops. Then a few moments starts again, and so on until eventually it starts and continues. I have checked...