Thanks guys it was CH Flow switch/ Throttle. How do you do a fan pressure test ive found some data in the manufac instructions but not sure is a electronic manometer test? Be interested to know as new to game
Thanks
gOT a BRITTONY SE80 EVRY TIME IT FIRES UP IT TRIPS RING MAIN. RING MAIN OK TESTED FOR INSULATION, POLARITY ETC. ANY TIPS ON WHERE TO START ON BOILER RECENTLY HAD A NEW PCB. OBVIOUS POWER PROBLEM SOMEWHERE NOT SURE WHERE TO START. PCB :cry: 2A FUSES OK NEVER BLOWN
No correct Diaphragm, I got a Second- Hand water section of a scrapped Brittony 2T and replaced along with the Diaphragm and it worked ok i think looking at the old 1 it was slighty distorted and wasn't sitting quite true. All ok now and it fired up great guns and flow and temp ok. Above all i...
I put a second-hand Water section on the damn thing and it worked. Your right about the Diaphragms being very similar for the Celtic and The Brittony 2T. Thanks All :D
No but what made me wonder was that i remember a gasket being on 1 i changed a while ago. i've put a new diaphragm in the right way but water keeps seeping out all round the sides of the housing its the correct diaphragm and the fitting is secure i.e all six screws are tight but why is it...
replaced a diaphgram in a brittony 2t is it supposed to have a gasket as well as its now leaking. It has a water section repair kit in place and the body is brass. But didn\\\'t seem to have a gasket when it came off! Just a worn rubber diaphgram
Attended a Breakdown of a Chaff SE80 Symptoms:Locking Out No sparking. Cleaned Fan up cleaned all terminals around APS as plastering recently carried out, carried out a full clean up got going ok CH & DHW Temps ok left running for a couple of hours no problem. Been back 3 times same problem but...
Sounds like trapped air lock in system. Try draining and refilling to try and shift it or cranking open rads on the big nut ends as oppossed to the bleed screws, sometimes shifts an air lock. Also vent pump.
What isolating valve???? As i said flow rate and water temp ok. There is no isolating valve on hot water outlet. Cold Water inlet opened and stop cock nothing restricting flow to appliance.