I drilled a pilot hole where the top screw would go (90mm from window) and I got 30ish mm in and hit something hard. Drilled a slightly bigger hole and I can see metal.
Would a lintel be plastered over with 30mm of plaster without any masonry? I always thought metal lintels looked like this...
Thanks for everyone’s replies.
The plinth is 100mm above the window.
Something no one’s suggested is attaching the brackets directly below the plinth, the bottom screw would be 60mm from the window.
I’ve got brown wall plugs and appropriate screws.
Thoughts?
Hi everyone,
Recently moved and looking to put up curtain poles but nearly every window has a wooden batten above the window.
This wouldn’t normally be an issue but where I’d like to attach the brackets would be very close to the top/bottom of the wooden plinth. Therefore imo not providing...
Hi everyone,
Thought I'd post an update.
I purchased a new stabiliser valve assembly and fitted it tonight.Here's my guide to replacing it.
Turn off water, turn off electric.
See previous post for picture of shower unit with numbers
Unplug No11 from circuit board
Unplug the...
Hi seco,
thanks for the reply, not sure why i thought they were transformers :oops: as you right.
I've ordered a new stabiliser valve, should be here tues or wed, are they messy/easy to replace?
thanks in advance
alex
Update,
I've been investigating a bit more this morning, I turned the pressure down and found that the water isnt actually coming from the stabilising assembly. So I took the stepper motor off and turned the electric on. The stepper motor turns(as it should) but the water actually comes from...
Hi everyone,
I've used this forum many a time to solve my problems but this is the first time I've had to actually post a message asking for me, go easy.
My mum, bless her, has a triton t300si remote shower, which use to have a ridiculous amount of pressure. Recently it got...