Recent content by aliff

Hi, I went into the engineer menu 1 and pressed A the buzzer sounded but nothing on the panel ,then I pressed B but again nothing on the panel and no buzzer sounded. I then pressed C and got Engineer On Site message, I pressed ESC for the message to disappear with no luck. I also tried the...

Unfortunately I do have the engineer manual, but have tried the engineer code 1234 and got in the engineer menu 1 ENGR 1 however from there I don't know what to do and don't want to mess the alarm up. What is a power cycle of the system? Do you think I might have pressed the wrong button...

Hi, I would very much appreciate if someone could advise me on how to clear the RESET CONFIG message that I am now getting. Thank you.

Hi, I have opened the panel and slide the red section, then my entered my code and press ESC, it is now flashing CONFIG RESET, what do I do now, I appreciate your advice. Thank you.

Hello, The manual does not say anything about this fault finding. Please see link below for the manual. It is on Page 40 Fault Finding. berkeleyguard.com/wp-content/uploads/2014/07/TS690use Looking at the back of manual, the engineer has recorded Circuit 7 as PAB FRONT DOOR under...

Hello Everyone, I need your advice on how to clear CCT 07-A which is appearing on the panel of my alarm. I have tried to clear it by putting my code and pressing ESC but the screen come back with the same message instead of showing the time. I can get into the user 1 and User 2 menu but need...