Recent content by Allanb79

Thanks. I'll take a look at this. I have heard that mentioned before but as the existing wiring is in place and currently switched off/isolated at CU. I'm basically just linking up to the JB that was disconnected when the cornice was replaced/repaired. I just didn't see what order the cables...

Thanks. Of course I meant Neutral. I've been looking at the bank balances before payday and have it on the brain :roll: :lol: I thought I could go as low as 1mm but I only have a reel of 1.5 It's literally a 1.5m run to the JB. Cheers JB is located ontop of the cuboard. Not...

Can someone kindly tell me if I have this correct for the switched live connection? I have some brown sleaving for the negative. In addition for some reason 2.5mm cable was used from the rocker switch to the JB. I should be able to use 1.5mm shouldn't I to make it a bit easier to route to...

Thanks guys. I'm not sure about wiring the switch to a 3amp plug side but the grid switch does not have a fuse. If I replace the cooker hood module 20A switch with a 3amp fuse module then I assume I can't run the 13amp socket from this and then the lights without at least adding more...

Thanks for the reply. To be honest I'm not sure of the correct term for the downlights. They are just 4 small kitchen spotlights for under cupboards from Howdens. Are you saying I can put the fused unit in place of the cooker hood socket then take a socket and lights from this? FCU >...

http://i55.tinypic.com/2znqp1c.jpg Can someone confirm if the wiring circled in blue will be fine to pass a Part P inspection?. I have a new build house and I wanted to add downlights in the kitchen. However I know you can't spur off a spur but is it ok to spur for downlights. Low voltage...