Recent content by allmac

Hi the other issue I had along with the PCB was the expansion vessel had collapsed and hand to be re expanded using a pump fixed both these problems and boiler has been working fine now. Alister

fitted a new pcb and it fixed the problem :) happy days

thanks Tony for your advice, I was looking to see if it was something simple before having to get some one out to have a look at it. When I turn on the hot water the boiler will light then stay lit for 3 or 4 min the electrodes keep spark the entire time. then the ignition failure lock out...

I am having a problem with a Ariston micro Genus 27 mffi it fires up getting the temperature up then switching off, when I have it in service mode it will burn on full till the water gets up to temp then it switches of then will relight when the temp drops. and so on. this happens on both ch...

Hi i was looking at replacing the drum bearing on a hotpoint wt640 i have done a couple before on different models, having a look at the drum it appears to clip together. before i spend time on taking the drum out i thought i would check and see if it is easy enough to split the drum? thanks Al

i need a new pcb for a hotpoint wma35 any recommendations where to get one cheep? thanks A.

OK i will do. i guess if any are broken or worn i should re-solder them?

It was a red one the same as the one i took off the door locks when i select a program it just wont start any of the cycles. The door light keeps flashing. thanks A.

hi the door handle is fine i fixed the spring that was a bit worn also replace the door switch. nothing happens when i slam the door. There is some chairing just above the large block on picture 1. i will clean it up and think i might just solder the 1st black block as it is looking a bit loose...

hi i have taken 3 pictures in sequence moving along the board. thanks A [/img]

Thanks Rock When you say i can repair the tracks with a soldering iron. what am i looking for on the board. there are a 3 small black bars on the back just up from one of the cable blocks they have a bit of black soot round them is this what you are talking about? Thanks again A.