Recent content by allutonee

thanks for your help in this, its ok, I have the manusl online. I'm going to give them a call and see what they say Thanks

I done quite a few things which i think messed the system up. I put some metal across the E and F signs while disconnecting the battery and 12v power cable and then switched it on again. That did not work I then done the same thing but instead of putting the metal piece between the E and F...

Well i've gone and messed myself up now... I tried to reset the code but nothing happened. Now my alarm does not make any voice announcements and does not say if my doors have been opened or not. Also it does not call my phone if i open a tamper. And it does not say "Alarm enabled, please...

ahh brilliant ukrobj! If possible, could you point me to the instructions you were following? I;'ve got the powermax complete I have 3 jumper pins i think marked DEF, do i just place some metal so it is touching all three of the pins while the power is off? Also, should the siren go off...

thanks for all the responses guys, I am most likely give them a call today and ask them to reset, and keep the code with me this time.... you live, you learn :)

Thanks secureiam, so basically I will have to go back to square one? Does it take long to program? I am quite good at these types of things but just wondering if it's more hassle than it's worth? (opposed to calling someone out) Thanks for your comments jackrae, but I won't be requesting...

Oh...i am following this below information. Will doing the below reset the whole system requiring me to program again or just the installer code? How easy will it be to program the system? Apologies for the many questions ----------------------------------------------------- Remove all...

They said it is the same installer code they use for all the systems they install so won't be able to provide it, they can only come and reset the code which will result in a call out charge They guy on the phone was quite good, he said that there is a way to reset the code myself but I am...

Hi guys, I cannot delete the PIR as I don't have the installer code and the supplier will not tell me it (security reasons) They can reset but have call out charge etc In the settings, I don't have an option to do a Bypass, i have checked the user manual and it states there is a bypass...

I looked for the option but could not find it in the settings, in the manual it say's there is a Bypass option but when I go into the User settings menu it takes me straight to "User telephone numbers" or something like that Yes, the Living room sensor had low battery, battery was changed but...

Hi all, Hope you are well First time posting, go easy on me :) I purchased the Powermax system 5 years ago and it was all fine until i was abroad and my brother changed one of the batteries that said low sensors on the PIR. Since then, whenever I leave the house sometime between 5...