Recent content by amwc

Hi How long would it take to change a faulty heating element in a Cylinder? Thank for any help in advance A

Hi thanks for the replies the radiator is what’s commonly known as a designer radiator and is probably less than 10mm off the wall and you can see through the slats to the wall behind. But one of these suggestions will probably work cheers

Hi I need to drain a CH system to paint behind a radiator but there are no drain points on the lower system. What is the best way to do this to avoid a flood? I can reduce the pressure from the boiler drain. Regards

Really? That surprises me.

Hi I am just wondering what the m2 price difference is for a loft conversion against an extension on new foundations. If the extension is £2k a square meter what would the equivalent loft be? both to a plastered finish. Thanks in advance

Hi all how much should a 3 ply felt roof cost per m2 ? I have a 4 x 6 flat roof extension to cover Any help appreciated Regards Sid

Hi Does any one know how much (roughly) it costs do divert the over head power lines. At the moment mine go to the back of my garage and I want it to come into the front so a shortening of 7m Thanks in advance

There’s 2 sand mixes available sharp to soft mix 70 % sharp to 30 % soft or 50-50

What sand are bricklayers generally using to Kay bricks? 70-30 or 50-50 ? Cheers in advance

I just want to pick up the toilet waste and consolidate the rest and get it out of the way of a potential extension but leave the vent part of it where is. It may look a bit odd but you won’t see it

Hi I am just wondering if changing the location of the svp as per the photo is acceptable? I don’t want to mess with the roof if I don’t have to Thanks

It’s a flat roof btw

I’m looking to build a 6x3 single story extension and trying to work out how much insulation I need for roof and floor. Obviously it’s 18m2 but how much insulation would you buy to cover this with cuts waste etc? Thanks for any help

Hi What’s the best way to cut through a stone lintel over a fire place? I have one that goes the full width and I only want to cut out the bit over the opening not the bearing Thanks in advance

Hi thanks for the reply but unfortunately it’s not a catnic, IG or keystone as far as I can tell