Recent content by Andy fin

Can anybody help !!!!!! Have Indesit Waching machine 1400 WIL 1435 Silver fronted. The problem is that it runs for a while through the cycles and then stops. I believe it is before the spin cycle (so the wife says!) it then flashes up two leds on the front panel (extra rinse and stain...

Hi All My pilot light keeps going out any Ideas!!!!! Due to another problem I have just replaced the modulator board and the pressure relief valve. This problem has happens every other day! Pressure ok all running normal. :cry: Thanks Andy

Have been all over board found a few dodgy joints but still have same problem have even removed relays and sprayed them with switch cleaner as were pitted. The only way to get the relay to enegize is to tap it, i thinks its time for a new board. Have just had a look on ebay and have spotted one...

After futhur investigation that it seems to be the mod board. Every time i tap the hot water relay on board i get hot water! Does anybody know where I can pick up a board from at a reasonable price ! It Is listed as potterton part no 929685 Gas council No 289550 (Piolot version) Thanks Af

Just saw you message gaz yes the modulator board led is lighting up when hot water tap is turned on, Which micro switch would you suggest and where is it located, can I test ! I Have got the original installation manual that came with bolier. in which i can relate to on diagram Thanks Af

Did what u said allowed for cooldown and water is still luke warm and pressure of water is low. Ran bath with no heating on and radiators did not get warm. Would you say it is the diverter valve ? is there any othe way of proving it? can it be freed up? Thanks AF

Hello all can any body help with Potterton Puma 80. Central heating works fine but upon turning on the hot water tap the water is hot for a split second and then runs luke warm . Have had the usual low pressure problems before. Any Ideas!!!!!!!!!!!!!