Recent content by Andy in Bristol

Hi Olly, Thanks both for reading my lengthy note and your similarly comprehensive reply. I've not taken the plunge just yet, and may hold off a little longer given that Spring has sprung(!) and consider implementing this set up ahead of next winter. If it occurs to you to drop a short note to...

Hi All, Before I go into a little detail, thanks in advance for anyone willing to read on and offer their thoughts... The "executive summary" of what follows is to ask for opinions and advice, please, on whether I should (a) spend more money and go down a Honeywell-only route to add their...

For the benefit of anyone else that may find this post in future, it turned out, following secureiam's helpful suggestion, that tapping the magnetic switch "released" the stuck reed. It was fairly gentle tapping with the handle of a screwdriver, and only on the outside of the unit so it did not...

Thanks again! Andy.

Many thanks for such a swift response secureiam, I had suspected a hardware issue. Is there anything else that you (or anyone else) would recommend that I can do to check/confirm this, please, or is it really now a matter of replacing the sensor and then seeing if that resolves the issue...

Hello All, I'm a new member to this forum, so please excuse me if I don't follow accepted practice for some reason (and let me know how to do better in future!) I have been searching around this forum (and more widely) to a solution to a recent problem, but to no avail. I'll try to explain as...