What is the minimum amount of time that you could expect to lay Amtico on a newly laid screed (about 3mm)? I've had a screed put down (on top of asphalt) and the floor was then primed 2hrs later, and Amtico laid an hour after that. Think screed was water-based but not 100% sure. The humidity...
Well plywood does expand and should be laid with expansion gaps. A problem could be caused by heat or moisture and if there are no gaps the ply could expand/swell upwards. Are there CH or hot water pipes underneath the floor at the point where the problem is occurring? Has the amtico been...
Have you tried contacting Amtico technical department for advice? I had a serious problem with my Amtico floor a couple of years ago and contacted them to discuss the problem and get advice. It resulted in a site visit from their technical manager to look at the problem first hand. After...
Stopgap300. it's only 1-2mm thick. Was supposed to be getting Amtico-approved installer. The guy who turned up wasn't. Long story/history about this job.
28 hrs later and still not dry in places. I can run my finger lightly across the wet bits and get a skim of wet screed on my finger (compared to the dry bits where they is a flaky surface coating). Needless to say, nothing has been laid today
Temp indoors has been 18 degrees all day - it...
Thanks. Found out last night that floorer admitted he watered down the screed to get it to run better. Have got up this morning - still wet, still mushy in places. What has dried it now crumbly and dusty and breaks up when you run your finger over it.
Ok will do, thank you. Floorers said themselves 2-3hrs and couldn't understand why it was still wet 6hrs later when I called them.
If screed has been incorrectly prepared, what impact might this have on a vinyl tile going down? I'm concerned about screed being too soft, or breaking up, or...
Hi, just after some advice/reassurance. Having a bit of a nightmare with an Amtico floor at the moment. It was laid last week and pulled up today as it was poorly fitted (subfloor preparation not as good as it should have been; lots of ripples and bumps).
The adhesive was scraped off and...