Recent content by AndyG_NI

Thanks stem, the zigbee thermostats are battery powered and will be controlled via home assistant which can then tell the hive to turn off / on as required. Regarding the wiring of the hive backplate am I correct above? This location is only used a couple of times a week for a couple of hours a...

Haven't seen any evidence of one. The cables coming through are 2 x t&e and 1 x 5 core of which 4 cores are used

Dual channel is the version I was going for, leaving the wired thermostats in place, but controlling via home assistant and zigbee thermostats as I have done at our other site. With the rads as heating channel and ufh as hot water. So to confirm, from my picture: leave out the loops to 2 and 5...

And so to convert this to hive just put that connection to L on the hive backplate?

Thanks, I saw that but there is another wire connected to point 5, which I think could just go to L? Or am I wrong

Hi, I'm a member of a sports club and we need to convert our heating programmer from a horstmann channelplus xl h27. I have attached an image of the wiring backplate. This system comprises a combi boiler, underfloor heating downstairs (2 thermostats) and radiator heating upstairs. There are two...

Ian, thank you very much for your help, and for not making me feel as stupid as my questions must have been. Have a good Christmas

So as there is no current stat, just two core flex from boiler to heat link and if it doesn't work switch the wires e.g. blue wire to co brown to no, if doesn't work then brown to co and blue to no?

Thanks very much, one final question, is there anyway to identify common and normally open?

Ian, Thanks - is the nest e not limited to low voltage? Can it handle full 240?

I have a net connection in the van. I think I need to use the 230v combi diagram as shown below. To connect I think wiring would be: 4 core cable, l & n joined boiler to heatlink, link wire between live and , wire from boiler port marked timer to heatlink normally open port 3

Haven't bought any model as yet

Hi, I would like to add a thermostat to my caravan boiler. The boiler is a morco gb24. It has connectivity for a thermostat but I'm not sure what wiring diagram from nest I should use. I think taking L and N from boiler to nest heatlink and then two wires from the boiler thermostat connection to...