Recent content by AndyJ

Hi all, On the basis that the only stupid question is the one that is not asked ..... I've got a power adapter that I use to charge a Li-Ion battery. The power cable end that plugs into the mains is European style on the mains end and cloverleaf on the end that plugs into the adapter. I...

Or maybe its POTTERTON NETAHEAT 10/16 PCB 205294 ?

doh .. I've been looking at the wrong thing. I was looking at the spark generator, not the PCB. Aftermarket (reconditioned) PCB's seem to a plenty for this boiler. Code seems to be POTTERTON NETAHEAT 10/16 PCB 205295. Is there any reason (other than the obvious, "we'd like to install a...

Boiler stopped working Friday evening. I noticed the 1amp fuse on the front had blown. I replaced this and this got the boiler working again. However, 2 hrs later, the boiler stopped working, and the fuse has NOT blown. Turning the dial no longer shows any spark inside. There' a click...

Hi all, I've got a sick Potterton Netaheat Mk2 10/16, which has been diagnosed with a faulty PCB. An engineer I had out popped along to his local supplier and picked up a replacement PCB, only to find it was the wrong type. Another trip resulted in yet another wrong PCB. A phone call to Baxi...

Thanks chaps. At the affected tap is a mixer tap, I tried the method of holding the outlet of the tap, turning on hot, then cold for 30 seconds - made no difference. Tried this about 3 or 4 times. Then I attached the mains fed cold inlet to the washing to the hot inlet - I could feel the...

Hi guys - experiencing a multitude of problems at the moment. Appologies if this is too long and I'll excuse those that can't be bothered to read it all. About 18 months ago we had a Thermostatic Power Shower fitted and a 2bar pump. There was no shower before. Pump was installed by a...

After an 2 bar Easiboost shower pump sprang a leak, I've replaced it with a Salamander RSP50 connected to a thermostatic shower unit (which was there when the easiboost failed). After fitting, on full hot - no problem. On full cold, the water is "pulsing", or hunting as I think folk in the...

After 2 years and 1 week my Easiboost shower pump started to leak from the hot side. (1 week after warranty - strange eh?). Got new (shaft) seals, but cannot for the life of me, when taking the pump apart, how its leaking. Anyone had problem with this pump and fixed it? Or should I just...

My Showerforce Easiboost shower started leaking water from the hot water side last night. Typically, its 2 years and 1 week old (1 week over 2 year warranty). Bsaed on this, I decided to look at what was wrong. Seems that a washer has broken apart - although given that its on the hot water...

Second post for the night - hope there's no limit on the amount of knowledge I can suck from you guys (and gals!). I need to re balance our radiators, as we have two rads in the living/dining room that do not work, yet all other rads do. I've read guide after guide about how to balance...

I accidentally snapped our waste pipe (on that feeds a kitchen basin, and washing machine waste) to the outside drain. Looking at the pipework I saw 40mm written on it - measured it - and the OD was about 43mm (give or take a mm). Popped into Wickes and bought a some 40mm pushfit. It...

Thanks all. Answered all my Q's :)

Thanks ban-all-sheds.

Thanks for the clarification guys.