I believe it runs from the consumer unit which is located in the single storey garage, up through the garage lof space which has a small amount of insulation, maybe 50mm then under the floor boards and into the airing cupboard. If the route is vital for the calculation then I can find out...
Hi, all. A friend of mine has just had a new boiler and cntral heating system to replace his original one. For some reason, the old immersion heater was connected to 1.5mmT&E. The electrician that came to wire up the new system including the new immersion heater, said that the 1.5mm T&E cable...
Thanks for your replies guys:
Gordongas. Yes all radiators have rad valves except ofcourse the room in which stat is set.
Whatdoiknow: The digital display gives a two figure number, but I am presuming that this is the temperature of water actually in the boiler as it displays aprox 76/77 when...
I have a fairly new central heating system(aprox 2years old). The main boiler is a Worcester Bosch HE30 combi. It is fitted with night setback timer(which works fine) and a TR2 room thermostat. The problem I am having is that the actual room temperature has to drop far below the temperature that...
Generally speaking, its advisable to change spider anyway as more often than not, the bearings wear a groove in the shaft of the spider. The spider and bearings can usually be purchased for around £25.00
Hi there. I was wondering if anyone could advise me on a good website to visit to find out exactly what we can and can't do as regards to connecting electrical appliances to existing circuits. I have read various websites about the part P regs but am confused about the "kitchens and bathrooms"...