Thanks for your reply, I think I have accidentally confused the issue. I have had a complete rewire so I already have a new consumer unit in place so all good there. I don’t intend on actually installing them myself, I’m just thinking of running in suitable cable to save a bit of money by...
I have a quick question, I am getting my rendering done on my extension and wanted to clarify I can do what I think I can do for the outside lighting. The fuse board location is on the first floor as shown on the drawn picture. I have four post lights that I want to position as shown by the...
https://www.ebay.co.uk/itm/Knightsbridge-1-x-58w-T8-high-frequency-ballast-non-dimmable-T8-58W-S5A-/253540376811?mkcid=16&mkevt=1&_trksid=p2349624.m46890.l6249&mkrid=710-127635-2958-0
Would this one be suitable also? Just asking because I saw somebody had reviewed the Tridonic and said it’s not...
I have a T8 ballast to replace in my strip light. I took it down hoping to replace it with exactly the same part. However I don’t seem to be able to locate the particular one that’s in there. I’m not sure which spec I have to be careful to match to ensure it’s the best alternative and make...
Long story short, my builder forgot to put the ducting in for my downdraft extractor. Have managed to channel cut underneath the concrete to get it all in and almost there!
I have a Smeg SP150 flat channel ducting kit. There are a couple of parts that I don’t really know where they are meant...
I don’t know. I have two of the svelte radiators and both have the same screws, just one rad is missing two. Perhaps I’m looking in the wrong place by looking for an M5 screw then as these are machine screws and perhaps not the right type.
I’ve tried them already... I’ve probably looked at all on eBay there is and when no size quoted have enquired. I don’t get why they are so difficult to get hold of. M4 head on an M5 body. Very strange but obviously they can’t just be especially made for Crosswater. It’s bizarre...