Recent content by angularbanjo

  1. A

    Painting a kitchen mixer tap, possible?

    Thanks, really helpful, spout comes off easily so that will help with the masking. Off to look online for etch primer now!
  2. A

    Painting a kitchen mixer tap, possible?

    Hi, as you can see from the attached photo our kitchen mixer tap is looking a bit sorry for itself but works fine. The chrome on the spout/base and handle will come up fine with a bit of a clean and polish but I was wondering about the matt black paint on the rectangular block which is peeling...
  3. A

    New threshold strip or get away with rubber seal?

    Hi there Our back door which is about 15 years old is letting in a serious draft at the bottom. I've attached a picture to show what's going on. Looks like the rubber seal on the threshold strip has given up the ghost. What I'm wondering is, can I just replace the rubber seal and if so, with...
  4. A

    Renewing leaky pipework from cloakroom sink

    Hi, I noticed that my cloakroom sink wasn't properly fixed to the wall and lo and behold, turns out it was screwed straight into the plasterboard by whoever installed it. I moved the sink a bit to install gripits into the plasterboard to hopefully secure it a bit better but then found that the...
  5. A

    penetrative damp on exposed wall. Solutions?

    Thanks for the replies, neighbour who is a skilled handyman pointed out some gaps just below the tiles on the roof where it meets the wall where rain could be getting in. The damp is most apparent upstairs (still very slight) so the plan is: fill those gaps with sticksall or suchlike, remove the...
  6. A

    penetrative damp on exposed wall. Solutions?

    Yes, the render sits on a ledge which slightly angles back up into the brickwork, sits about an inch proud. Must just be the photo but the brick is bone dry.
  7. A

    penetrative damp on exposed wall. Solutions?

    Hi, we have a 1970's detached single cavity construction house (block and brick) where there seems to be a problem with a wee bit of damp getting in upstairs via the wall shown in the pictures (see attached) The wall in question is actually part of a slightly later (80's) extension. The wall is...
  8. A

    Tilt and turn uPVC windows drafty....help!

    I'll do that tomorrow, many thanks.
  9. A

    Tilt and turn uPVC windows drafty....help!

    Hi, we have 2 uPVC tilt and turn double glased windows (about 15 years old, pretty bog standard I think) both of which feel drafty when closed down the hinge side (top to bottom). I'm guessing wind is somehow getting past the black rubber seal on the sash of the window which is meant to be...
  10. A

    condensation I think from extractor fan....fix?

    No, the fan itself is fine, not too noisy. I just don't put the light on at 3.00am when I'm up for a pee to stop myself waking up any more than necessary !
  11. A

    condensation I think from extractor fan....fix?

    Yes there is a rain cap. Problem with that WC is we tend to only use it during the night and then we don't put the light on (I sit, my aims not that good!) so the extractor fan rarely turns on.
  12. A

    condensation I think from extractor fan....fix?

    Thanks, that makes perfect sense
  13. A

    condensation I think from extractor fan....fix?

    Hi Realise similar has been covered before but thought I would just check it out first. Our upstairs WC has an extractor fan which is ducted out vertically through the attic. It's dripping water through the fan opening which I'm guessing will be condensation? I've attached a photo of the...
Back
Top