Recent content by Anthony CLARKE

Hi Guys. Hob arrived today. No 'Terminal Block' as such. Cable attached with four connections - brown & black, Blue and green. Simply connected to a junction box with existing wire (which is connected to 'Big Red Switch' and all working fine. Many thanks for your input. As ever, much...

terry plumb: Many thanks. I will post a photo of terminal block when the hob arrives today.

I've taken a photo of it but still cannot get it to add in to my post. New Hob arrives tomorrow. I will photograph and post then.

Sorry can't get it to show actual wiring diagram

Installation Electrical connection WARNING- THIS APPLIANCE MUST BE EARTHED This appliance is designed to be connected to a 220-240V~50Hz/60Hz AC electricity supply. Before proceeding with the electrical connection, verify that the current carrying capacity of the system and the isolator...

TimboTwo: Only one N connection

Hob is 6Kw Installation Electrical connection WARNING- THIS APPLIANCE MUST BE EARTHED This appliance is designed to be connected to a 220-240V~50Hz/60Hz AC electricity supply. Before proceeding with the electrical connection, verify that the current carrying capacity of the system and...

Hi Guys: Just about to replace a Stoves ceramic hob with a Russell Hobbs version. Both are NON-INDUCTION. I see on the wiring diagram for the new unit that there are 4 connections - L1, L2, N and E. The N and E are easy enough but the only time I have come across L1 and L2 has been in...

Thanks, Ian. Always have several rolls in the toolkit. :)

Thanks for the information and your time. Both are much appreciated!

Many thanks for that. Just for my information, do the tails contain 'anything' required in the operation of the TRV? I wouldn't have thought so but just asking.

I have no photos as the site is my son's house some 200+ miles away (going there in a week or so). As far as using existing tails from old rad, I read somewhere not to do it as they are 'old' and may be difficult to separate?

Hi I will be replacing a single radiator with a double radiator in the near future. I have taken radiators off and replaced them in the past so it will hopefully be OK to do it. I am looking to replace with a rad of the same height and width. One thing I will obviously need to do is to fit...