Recent content by arinb12

  1. A

    Paint sample patches

    Hi guys, Wondering if you could give me some advice. We put some dulux sample patches on our walls and chose a colour. Before painting the new colour I rollered a couple of coats of white over the patches, let dry for a day and then painted the new paint in two coats. Problem is now where I...
  2. A

    Log Cabin

    yes
  3. A

    Building wooden shed

    and bump again
  4. A

    Log Cabin

    bump
  5. A

    Building wooden shed

    bump
  6. A

    Building wooden shed

    i'd like to build a side shed out of timber. I would be laying on existing decking, which has a strong foundation. can I build my floor frame directly on to the decking as it is? or not? what are my issues with that? When i build the wall frames - i want this shed to be fully insulated...
  7. A

    Log Cabin

    seems easier to go on top of the floor than lift and insulate? perhaps i should go for it. so i dont need to worry about the insulation underneath the floor held by chicken wire getting damp with cold air?
  8. A

    Log Cabin

    Hi all, We have had a log cabin build for some time now. Came as a kit but was never insulated. it is build on a concrete base with raised rafters - cabin built on raised rafters, so does not touch the floor. There is an open crawl space under the floor which is installed. What are...
  9. A

    scantronic 9800

    Hi there Thanks ever so much for the help sparky and redpis It's an EXEL XL93LC46P.. side note where does the red and black wire go for the speaker ? Across the two ls terminals and not to 12v etc (i assume the ls terminals provide the relevant power) Ta
  10. A

    scantronic 9800

    Broke a leg of nv ram chip resetting it. Any idea where or what chip I can use as replacement?
  11. A

    scantronic 9800

    Is black wire to ls and red to 12v then? Thanks
  12. A

    scantronic 9800

    http://imageshack.us/g/1/9875357/ as a side note, is it worth replacing this alarm system. obviously I have all wiring in place to sensors and pirs. But if its worth upgrading. do you have any good alarm reccomendations (obv not too expensive) - keeping sensors and pirs.
  13. A

    scantronic 9800

    originally it sounded when the alarm went off... and also beeped when the battery was low (or the mains unplugged) it was originally wired in somewhere ... on the board that has BUR and AUX and lots of NC's and NO's but i cant remember where on there it was.
  14. A

    scantronic 9800

    internal bell/sounder wiring? I have a 12v internal bell/sounder to be wired into the alarm panel. I moved the alarm and didn't mark where it was wired in and now im stuck. any one able to tell me where it wires in? only two wires (red and blue) can take pictures if needed?
See more
Back
Top