Recent content by aris

I did some searches here and the question appears to be quite a can of worms! :LOL: I have a Valliant 282e which has a secondary heat exchanger which is clogging up on a regular basis. I do flush and put in inhibitor in every year - but regardless, this is happening. I think I need a filter...

What is the digi-lan option? Similar to GPRS? But Ethernet based? Has anyone used the HomeControl+ units? Are they GPRS? Docs on these units are hard to come by!

It is certainly trivial enough to do.

Only the obvious CCTV cameras you can see :whistle:(y)

Have you interfaced the X10 to the Enforcer? What kind of home automation options are available from the Enforcer? Do you think it uses data when not in use?

Bit of Google-Fu found an old Pyronix roadmap that have a DIGI-GPRS, DIGI-LAN, and DIGI-WIFI modules. Well these were on the roadmap for release November 2014 :) So I presume they are still coming. It also speaks of a home automation module, and Video Cloud storage.

I'm not hung up on the camera stuff - though if it can be added to existing system in the future - fantastic! Same with home automation. A nice to have, and I can wait if it is just a software update, or buying some extra bits (i'm hoping they will use some sort of industry standard like X10)...

I'm curious to know how about the Pyronix Enforcer HomeControl+ Panel if you would like to post an update. Information on the tecnicalities of it seem very very slim on the ground. I did find a Russian site which mentioned integration of CCTV to this system - but nowhere else. One thing i'd...

I take it your alarm is not monitored. Has it gone off while you were away - and if so what did you do? Does it continue to sound forever until someone switches it off? Could be annoying!

I don't know - hence why i'm asking someone with 20/20 hindsight :)

Might have going the Texecom route been better? Would it support remote disarm/arm?

Sorry to drag up an old thread, but my needs are the same. What did you go for in the end and how did it work out? Did you have to buy any extra bits for the GSM integration and is it reliable?

This for the response. I did watch it drain and fill a few times and it looked ok. My initial problem was dishes and glasses which were not entirely clean. I cleaned up some muck in the spray arms and set a few 70 degree washes to clear up any fatty deposits - so lets see what happens.

I am having a similar problem here. I believe it is the fill chamber / matrix which is the issue. The blockage seems to be on the left of the image (a close-up provided too). I've been watching it drain on a cycle, and i'm wondering what that area actually does - or if it has any effect at...

This is on a closed system for the CH water. I notice that the pressure goes way low - almost to zero. When the CH comes on, it goes way up again - to just above 2 (which I suspect is my mains water pressure). I thought there could be a leak in the CH - and even bought some Fernox F4...