Recent content by asikus

Hi thanks for the reply, I did a few checks. First without opening front of the dishwasher at all I used a screwdriver to push the door switch is a closed position. The spring mechanism clicks. When I opened the door and chose a program the cycle would start. When I closed the door the cycle...

Hi I have a Candy CDI 1012 integrated dishwasher. Suddenly for no apparent reason the cycle would not start when I closed the door. There is power going to the machine and I am able to select a wash program. Normally the sequence of operation is as follows 1) Open door select program 2)...

The problem was that a couple of the wires which run from the control switch to under the machine were snapped within the harness at the bottom of the door. The harness was also damaged. I replaced the broken wires by splicing a new wire to connect them together. I had to cut out around...

Thanks for replies 1) rocks thanks for the hint :) Do you know specifically where in Bosch to contact and secondly whether they provide this information? 2) assulhors: I will check these areas. If I can't get anywhere with this I am going to try the haynes manual for dishwashers from my...

Hello All, My Bosch SMS 603 diswasher stopped working mid cycle and will not start. There is power to the machine as the salt indicator is on. The neon bulb (I say neon from inspection and I am not 100% sure) indicating machine on or off does not come on when the on off button is switched...

The problem was due the insulation board in the combustion chamber breaking and consequently covering the pilot assembly and burner. It was a blessing that the problem did occur so I was able to fix it. To correct the problem I simply put back the insulation material using the metal clips...

Hello all, My Potterton Ultra2 40DV (sealed system) has an ignition problem. When switched on the ignition sequence starts clicking, creating a spark. The pilot light comes on, however the clicking continues (with the sparks in the boiler) and the boiler fails to light. I have to switch the...