Recent content by AustinYeahbaby

It does broadcast the ssid but the password always comes back as invalid when trying to join I’ve then tried resetting the ssid password by pressing the button on the smartcom about 10 times quickly, all leds flash rapidly as it resets snd reboots but same pronlem. Connecting a lan cable to...

Thanks for the reply, The firmare is the latest 4.06.01 I've connected via ethernet as per above and only seem to get half a config page no wifi config. I've pressed the button a load of times and all the leds flash to indicate reset and it does reboot but same result

I have a Texecom Smarcom V2 that has lost wifi connection to my router. I've tried to access the Smartcom config page but with no luck via phone as it says incorrect password. I pressed the internal button 5 times and that reset the device but still can't login. I've connected a ethernet...

Thanks @secureiam, I already got a replacement panel so good to go on that front. I was just trying to work out the easiest way to migrate to the new panel. if for example I delete the wireless bell box from the existing panel then I’m presuming it won’t fault when I remove the existing panel...

Hi, I have a Texecom premier elite 48w ricochet panel/bells/sensors but looking to change the panel for a later model I bought that supports wireless keypads. All the existing pir/door/bell sensors are connected wirelessly, the only wired aspect is the existing keypad. can anyone give any...

Would the microswitch cause the pump to stay on even when the controller has HW + CH set to off?

The only thing I can think is when I changed the program timer last year from a Drayton Lifestyle 241 to a Drayton Tempus 6. I just checked the wiring diagram on the drayton site and both look the same. I wondering if the boost option or some other difference between the controllers is...

No, the boiler does not fire up at all until the clock controller starts up through the timer/advance or boost button. What's weird is that I set both HW + CH to advance, boiler kicks in, central heating and water get hot as normal. The water timer ends (as normal or via the advance...

Ideal Classic FF280m when I say the boiler power is off, I'm talking about using the power switch on the front of the boiler set to off but the fused spare next to the controller set to on still.

The boiler does not fire up, the pump even runs with the power off to the boiler :(

Hi, first post. I have an ideal classic FF280 The pump in the airing cupboard is continuously on even when both the central heating/hot water is set to off. Even if I turn off the boiler, it keeps going! The only way I can get it to stop is either turn the power off next to the...