Recent content by autoxtraz

Sorted - simply. Found a 30deg 110mm single socket push fit then a Flexseal dc115 rubber coupling to join to existing Bartol pipe. This then allows the flexi pan connector to drop in to 30deg socket at much shallower angle into soil pipe. Job done. Only grief was trying to find a Flexseal...

Thats a 10" section that went through from eves-bathroom and the pan connected to it but as stated the run was 17 degrees so the connection has to start obviously in the bathroom-through wall and then drop via flexi pipe and connect (somehow) from 110 to 105mm onto the grey soil in the eves...

All 20' foot of it? Where would I stop? The soil stack? the 2 bathroom sinks and bath that are all saddle strapped to it? At which point does it become stupid? The house was built 1980 and it's just impractical and cost prohibative to do that so the only sensible option is to find a simlar...

It's a bastardised set up. Grey pipe is stamped Bartol, orange painted fitting is Marley 110mm. As stated, but maybe not clearly, the inside of the Marley fitting has been ground out from 110 to 112mm to slide onto the Bartol pipe be approx 20mm then hot melt used for glue. The set up we just...

Hi all. Son just bought new house and need to adapt new toilet pan (upstairs bathroom) to old Bartol Grey waste pipe. Bartol is weld pipe approx 4.37" o/d-4.14" i/d (metric 112mm o/d -105mm 1/d) and would guess with this being a thicker pipe it's about 3.5-4mm wall thickness. Have bought a...