So i have a 3/4 to 3/4 bath connection to connect a mixer shower to the bathtub.
Link here:https://www.amazon.co.uk/gp/product/B003ZI47OE/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1
Only the specific mixer shower i want has a 1/2 connection (I want this as it has good Ltr/per min) there's a...
I pressume it's just above in the attic and the cold is very powerful so I guess it's mains. I think the shower head is close to the bottom of the tank maybe less than a meter as I'm tall and have it very high with about 1.5 m length hose
So when i run the tap the cold is powerful but the hot isn't.
The tank for hot is in airing cupboard, what mixer shower preferably about £100 should i be looking at as i guess it will equal around 0.1 Bar pressure.
Can anyone give me any suggestions.
One thing i'm confused on Mira showers say...
Were all easy to turn, turned them off as wanted to try to remove old taps in bath to install mixer taps.
Given up now though especially as hot water is gone, it happened before on two occasions then i had done nothing so might be something other causing, just this time the blocking one tap the...
All of them my mom isn't happy aha
Aha :p
Ah I have been trying with the two taps upstairs, thanks I will try on the mixer tap downstairs also well tomorrow :).
Thanks for help guys
Boiler by Awesome221 posted 31 Jul 2017 at 11:07 PM
Done, i think it might be a airlock as i put something over the cold before (months ago) and the water started to come out of the hot but now i'm having no success just spray everywhere.
Tried turning red cogs all anticlockwise also.
Thank you i appreciate reply, i didn't think it would.
The flexible tube will not bend easy at the angle if i cut before the elbow.
Hopefully if i get small copper tubes to connect one end to the elbow and the other the flexi hose that will be ok.
I think we have a combi boiler, i turned the three red stopcocks clockwise on the boiler to stop the hot water supply.
Ive gone to turn them on and no water from the hot tap?
Do you think an attachment like this http://www.screwfix.com/p/endex-straight-tap-connector-22mm-x/64190
would work as the hose will bend to a bad shape if i attach it directly to the copper pipe and i don't want to cut any pipe.
If so do you know if thats the correct size i would need?
Maybe...
I plan to install a bath - shower mixer tap.
The cold and hot are the wrong way around, so i needed flexible hose to swap them.
What i don't understand is how can i connect the flexible pipes to the 22mm end or the 15mm end to the receptive elbows shown in the below.
As it currently has the...