Recent content by badboilerz

Hi everyone, Was wondering if I can get some help. Our boiler has decided not to work at all, no central heating or hot water, the house is freezing cold :( The boiler is a Sintex Sarigas F20A combi gas. Problem: Boiler is showing green light and pressure is good at 1.5 - 2.0 bar...

Thanks picasso. I've never liked the boiler myself, just waiting for the right time to get a new one, too much on at the moment.. I've had a look in the manual the only thing that I can make out as the diaphragm is the divertor unit within the pump unit itself, is this the part you are...

Hi, yes the kitchen tap water is normally hot, it is however luke warm when the pressure or flow is full tap open. In between flow it usually stay hot/very hot..

:lol: Its ~10 years old. I'm going to have a look in the manual and see the wherabouts of the part you metioned.. Is the part serviceable at all? Or only to be replaced Thanks

Hi, It's a Sarigas F20A i think

Morning everyone, Just wondering if I could get some input on a problem we've been having with the Shower/Combi boiler for quite some time now.. We have a Mira mixer shower running of the combi boiler, it will run warm when you turn the temperature from cold to hot. All ready and good...

Hey guys, Can't find anything listed as the DHW or warm water switch... I've managed to get an explored diagram of the boiler uploaded and circled the part in red (item number 67 & 24) which I think maybe the DHW then? It is known as the "Noril body for flow detector"?! This is the...

Hi guys, Thought I would start a new thread, as I'm in two minds whether my pump is actually at fault or if it's something else playing up.. The other thread title is focused more on the pump, so this problem wouldn't get much attention in that thread... Problem- So I'll start from the...

Hi Matt, The original pump is a SariGas which is within the boiler body. The boiler is a SariGas F20A

I am thinking the problem lies more to do with the actual control box of my old pump, therefore, I was hoping to replace that with the new one on the pump itself. I think it would be possible to just swap the control box wires over to the new pump one as described in the 2nd pic, and the...

Thanks Paul, I'll check if that's possible, but I'm thinking the only thing that may be an issue could be that the new pump has a control knob for 3 speed settings and the old one didn't because it's a variably controlled one by the boiler, as Mike mentioned earlier. But, then again if I'm...

Hi Mike, Yes the existing pump is within the boiler body... So, that means I can't use any of these aftermarket pumps then... I thought this would be an easy check if the pump was faulty on the boiler. The boiler will automatically fire up and permanently stay on, heat up and then cut...

Hi guys, need some help with replacing my new wilo water pump in my boiler... I am having difficulty with the wiring on the new pump. when i removed my old pump i discovered 4 wires (brown (live), blue (neutral), green/yellow (earth) and black (ground). However the new pump instructions...

Hi everyone, I'm looking for some advice on how to go about repairing old window frames on my house... :shock: As you'll see from the pics, the skirting/cill (?) around the window was very badly damaged, so I've chiseled out the damaged part and now need to seal and finish it off with...

:) Wish it was that easy, the Neighbours aren't too bad they're just lazy.