Recent content by bedtester

I've found this product to add a 3rd spiet under the sink. I'd have to extend the dryer hose to reach it.

There's literally no room to squeeze a stand pipe behind the appliances, believe me I've tried. The waste hoses for the dishwasher and washer will fit and reach the sink trap spigets if I run them down the skirting recess behind the machines. The dryer hose is much to short but could tee into...

Is something like this ok to connect washer and condensing dryer to the same drain spiget. I was planning to fit a double stand pipe but room behind integrated appliances is proving challenging. Plan B is to run 2 waste pipes to the spigets under the sink. Dishwasher, Washer, dryer in that order...

Yep definitely demountable with the correct tool This fitting definitely not demountable, no release collet and you can't access the sharks teeth. If this helps others, I buzzed it off nice and square and clean just on the live side of the centre, then used what was left as a straight...

Is there anyway to demount this primaflow push fit, I have a tool like this but don't think it'll do it. If demounting is impossible, best way to remove it without ruining the pipe

It's not a one for one replacement. I've got to free up wall space for quartz splash back. A 2g cooker switch/socket is replacing a 1g switch and a separate 2g socket. Ideally it would match this cooker plate

Hay lovelies To save me getting the Vim powder out, does anyone know of a unlabeled brushed steel with white inserts cooker switch & socket. If labelled with boiler, even better.

Thank you, I'll aim to put them at 594ish, it's flexible barrier pipe anyway. I will add a couple of double 4x2 noggins top and bottom at 1600 centres to suit almost any 1800 tall rad Thank you again

Ok it's daft question, but not as daft as one that never got asked! I've installed 2kw/M underfloor heating under my new kitchen tile, fingers crossed this will be my primary heat source for years to come. It's electrical, so will fail one day soon or in 30 years time. As a contingency I've...

Yes, but I had better get it right before he sees it, just to save embarrassment

Crumbs, that last emoji didn't work, it was meant to be a shrug

Thanks for the help peeps, yes I'm quite comfortable with the math, Just been reading up in my latest copy of the requirements these books cost me half a crown they're that old Diversity = first 10A + 30% of remaining+ 5A for the 13amp outlet. Therefore 7530/230= 32.7A 32.7-15=17.5 30% of...

It's AEG Combi microwave KMX365060B Single oven with air fry BEX535A61B AEG Induction hob IKB64401FB Thanks for taking the time

Hello, I've seen a similar post here but not quite the same, mine is for three hard wired appliances. Going from one oven to two plus an induction hob replaceing a gas hob. I'm after a 3 cooker wiring diagram , I'm guessing it will involve 2x duel cooker plates or 60 amp junction box. Second...

Thanx pigeion85 you agree with my dad. It's just the chap on YouTube was going on about what a super glossy finish after the 2nd coat. I've always enjoyed doing my own home improvements :lol: and have done lots of painting but have only used retail paint, are the trade paints at a higher cost a...